David
02-13-2012, 12:22 PM
If your wiper blades are just smearing water across the glass rather than wiping it off, they need replacing. You should also check them regularly for cracks and brittleness. We recommend that you replace them at least once a year with official Fiat wiper blades - you can buy these from any dealer. They’re always willing to do the job quickly and safely for you if you don’t fancy doing it yourself. Your vehicle handbook will give you specific details about your model’s requirements.
http://www.fiatforever.com/images/imported/2012/02/541.jpg
Step one Raise the windscreen wiper arm off the windscreen. Position the wiper blade so that it forms a 90° angle with the arm. (You may want to take a digital photo of the blade set-up before you remove it – just in case you get stuck later.)
http://www.fiatforever.com/images/imported/2012/02/542.jpg
Step twoPress the tab of the coupling spring and remove the blade from the arm.
http://www.fiatforever.com/images/imported/2012/02/543.jpg
Step threeGet the new blade and make sure you have it the right way up. Fit the new blade by inserting the tab into the special slot in the arm. Make sure it’s properly locked into place (you should hear a click), and check that it’s sitting flush to the windscreen.
http://www.fiatforever.com/images/imported/2012/02/544.jpg
Step four Lower the wiper arm so that the blade sits neatly at the base of the screen. You can test that it wipes properly by turning it on, but don’t test it on a dry windscreen as that will damage your nice new blades.
http://www.fiatforever.com/images/imported/2012/02/541.jpg
Step one Raise the windscreen wiper arm off the windscreen. Position the wiper blade so that it forms a 90° angle with the arm. (You may want to take a digital photo of the blade set-up before you remove it – just in case you get stuck later.)
http://www.fiatforever.com/images/imported/2012/02/542.jpg
Step twoPress the tab of the coupling spring and remove the blade from the arm.
http://www.fiatforever.com/images/imported/2012/02/543.jpg
Step threeGet the new blade and make sure you have it the right way up. Fit the new blade by inserting the tab into the special slot in the arm. Make sure it’s properly locked into place (you should hear a click), and check that it’s sitting flush to the windscreen.
http://www.fiatforever.com/images/imported/2012/02/544.jpg
Step four Lower the wiper arm so that the blade sits neatly at the base of the screen. You can test that it wipes properly by turning it on, but don’t test it on a dry windscreen as that will damage your nice new blades.